Assemble

Assembly Procedure





1. Install the dimmer switch assembly (2) onto the ignition switch assembly (1).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the TORX (R) washer head screw (3).
^ Tighten the screw to 4 Nm (35 inch lbs.).
3. Install the dimmer switch rod (5).
4. Install the hexagon nut (4).
^ Tighten the nut to 4 Nm (35 inch lbs.).
5. Reconnect the dimmer switch connector onto the dimmer switch assembly (2).





6. Put the wire harness assembly into the wire harness strap (1).
7. Remove the column from the J41352.