Lock Housing - Assemble

Assembly Procedure





1. Lubricate the switch actuator pivot pin (2) with synthetic grease. Install the switch actuator pivot pin (2).
2. Install the pivot and pulse switch assembly (1) into the lock housing cover assembly.





3. Lubricate the dimmer switch rod actuator (3) with synthetic grease. Install the dimmer switch rod actuator (3) to the column housing cover end base plate (2).

Important: The bottom of the dimmer switch rod actuator (3) must rest on the bend of the dimmer switch rod.

4. Install the column housing cover end base plate (2) to the lock housing cover assembly (1).
5. Install the lock housing cover assembly (1) onto the steering column.
6. Align the dimmer switch rod to the dimmer switch rod actuator (3).

Notice: Refer to Fastener Notice in Service Precautions.





7. Install 3 pan head 6-lobe socket tapping screws. Tighten the screws (1) at 12 o'clock position first, screw (3) at 8 o'clock position second, and screw (2) at 3 o'clock position third.
- Tighten screws to 9 Nm (80 inch lbs.).





8. Mount the cruise control connector (3) onto the base plate (1).
9. Install the column housing cover end cap (2).
10. Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Assemble - Off Vehicle.