Radio, Stereo, and Compact Disc: Service and Repair
BOSE MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the rear window trim panel.
2. Remove the amplifier bracket screws from the rear parcel shelf.
3. Open the rear compartment lid.
4. Disengage the locator tabs (1, 2) on the amplifier bracket from the rear parcel shelf.
5. Lower the amplifier bracket (7) from the rear parcel shelf.
6. Remove the screws (3) from the radio signal processor module (5).
7. Remove the radio signal processor module (5) from the amplifier bracket (7).
8. Disconnect the two wiring harness connectors (4) from the radio signal processor module (5).
INSTALLATION PROCEDURE
1. Connect the two wiring harness connectors (4) to the radio signal processor module (5).
2. Install the radio signal processor module (5) into the amplifier bracket (7).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the screws (3) to the processor module (5).
Tighten
Tighten the screws to 2.5 N.m (22 lb in).
4. Install the amplifier bracket to the rear parcel shelf engaging the locator tabs (1, 2).
5. Install the amplifier bracket screws to the rear parcel shelf.
Tighten
Tighten the screws to 2 N.m (18 lb in).
6. Install the trim panel that covers the rear seat to the rear window.
7. Close the rear compartment lid.