Front Side Door Wiring Conduit Replacement

Front Side Door Wiring Conduit Replacement

Removal Procedure

Caution: Refer to SIR Caution in Cautions and Notices.

1. Disable the SIR system, if equipped with the SIR side impact system. Refer to Disabling the SIR System in SIR.




2. Disconnect the rubber conduit from door and pillar.
3. Loosen the plastic-type nut located on conduit closest to the door.
4. Grasp the conduit close to the end being removed.
5. Using a turning/pulling motion, remove the conduit.
6. Disconnect the wiring harness connectors.

Installation Procedure




1. Connect the wiring harness connectors.
2. Install the conduit using a turning-pushing motion into the door and the pillar.
3. Using a turning/push motion, install the conduit to the door and pillar.
4. Tighten the plastic-type nut located on conduit closest to the door.
5. Enable the SIR system, if equipped with the SIR side impact system. Refer to Enabling the SIR System in SIR.