Trunk / Liftgate Shock / Support: Service and Repair

Rear Compartment Lid Strut Replacement

Removal Procedure

Caution: When a rear compartment lid hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Important: The rear compartment lid struts are not adjustable. Replace the rear compartment lid struts if damaged and/or leaking. Replace only one rear compartment lid strut at a time.


1. Support the rear compartment lid.




2. Lift up the retainer clips on the strut ends.
3. Remove the rear compartment lid strut from the hinge.
4. Repeat step 1 through step 3 to remove the other rear compartment lid strut.

Installation Procedure





Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

1. Install the rear compartment lid strut to the hinge.
2. Push in on the rear compartment lid strut until it locks in place.
3. Remove the support from the rear compartment lid.
4. Repeat steps 1 through 3 to install the other rear compartment lid strut.