Lock Cylinder Replacement - Door
REMOVAL PROCEDURECAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system, if equipped with the SIR side impact system. Refer to Air Bag(s) Arming and Disarming in Restraint Systems.
2. Remove the front door trim panel.
3. Remove the front door water deflector.
4. Remove the front door outside handle.
5. Remove the front door outside handle lock rod.
6. Remove the C-Clip.
7. Remove the cam lever.
8. Remove the spring from the lock barrel.
9. Remove the thrust spring.
10. Remove the clear plastic cap.
11. Remove the door lock cylinder roll pin.
12. Insert the key into the lock cylinder.
13. Turn the lock cylinder to the right to release the cylinder from the lock plate.
14. Remove two ball bearings, two roller cylinder thrust caps.
15. Remove the lock cylinder from the cylinder housing.
INSTALLATION PROCEDURE
1. Install the lock cylinder to the cylinder housing.
2. Install two bail bearings, two roller cylinder thrust caps.
3. Turn the lock cylinder to the left to lock the cylinder to the lock plate.
4. Remove the key from the lock cylinder.
5. Install the door lock cylinder roll pin.
6. Install the clear plastic cap.
7. Install the thrust spring.
8. Install the cam lever.
9. Install the C-Clip.
10. Install the front door outside handle.
11. Install the front door water deflector.
12. Install front door trim panel.
13. Enable the SIR system, if equipped with the SIR side impact system. Refer to Air Bag(s) Arming and Disarming in Restraint Systems.