58. Cylinder Head Installation - Left

Cylinder Head Installation - Left

^ Tools Required
- J 36660-A Torque/Angle Meter





1. Install the new cylinder head gasket with OPEN/TOP imprint toward the front of the engine.
2. Install the cylinder head to the engine block.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the new cylinder head bolts.
Tighten the cylinder head bolts to 25 Nm (18 ft. lbs.).
4. Use the J 36660-A to rotate the cylinder head bolts in the following sequence:
4.1. The first pass rotate the cylinder head bolts 90 degrees.
4.2. The second pass rotate the cylinder head bolts 90 degrees.
4.3. The third pass rotate the cylinder head bolts 90 degrees.
4.4. The fourth pass rotate cylinder head bolts 15 degrees.
4.5. The fifth and final pass rotate the cylinder head bolts 15 degrees.