Headlamp Relay: Service and Repair

HEADLAMP RELAY REPLACEMENT

The low beam and high beam relays are located in the convenience center behind the I/P driver knee bolster energy absorber directly below the steering column.

Removal Procedure




1. Remove the self-locking screws from the I/P driver knee bolster energy absorber.
2. Slide the I/P driver knee bolster energy absorber upward to release the I/P driver knee bolster energy absorber from the tabs.
3. Remove the I/P driver knee bolster energy absorber.




4. Remove the low beam relay (2), high beam relay LH (5), high beam relay RH (8) from the convenience center.

Installation Procedure




1. Install the low beam (2), high beam relay LH (5), high beam relay RH (8) to the convenience center.




2. Slide the I/P driver knee bolster energy absorber downward to secure the I/P driver knee bolster energy absorber to the tabs to install the I/P driver knee bolster energy absorber.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the self-locking screws to the I/P driver knee bolster energy absorber.

Tighten
Tighten the self-locking screws to 2 N.m (18 lb in).