Transmission Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the vehicle speed sensor electrical connector.
3. Remove the vehicle speed sensor bolt (46).
4. Remove the vehicle speed sensor (45) and the seal (44). Use hand pressure to rotate the sensor back and forth while pulling outward. Do not pry on the sensor.

Installation Procedure





1. Install the seal (44) to the speed sensor (45).
2. Install the vehicle speed sensor to the transmission.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the speed sensor attaching bolt (46).
^ Tighten the speed sensor bolt to 9 Nm (78 inch lbs.).
4. Connect the vehicle speed sensor electrical connector.
5. Lower the vehicle.