Steering Wheel

Steering Wheel Replacement

- Tools Required
- J 1859-A Steering Wheel Puller
- J 36541-A Steering Wheel Puller Legs

Removal Procedure





1. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.
2. Reposition the locking tab on the steering wheel nut.
3. Remove the steering wheel nut.
4. Remove the steering wheel nut locking tab.
5. Matchmark the steering wheel to the steering column.

Notice: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.





6. Pull off the steering wheel using J 1859-A and J 36541-A.

Installation Procedure





1. Install the steering wheel to the column using the matchmarks.
2. Install the steering wheel nut locking tab.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the steering wheel nut.
- Tighten the nut to 28 Nm (21 ft. lbs.).
4. Secure the nut with the locking tab.
5. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.