Front

Stabilizer Shaft Replacement

- Tools Required
- J 36660-A Torque/Angle Meter

Removal Procedure





1. Raise and support the vehicle.
2. Remove the engine front crossmember frame.
3. Remove the stabilizer shaft insulator bolts.
4. Remove the stabilizer shaft.
5. Remove the insulators from the stabilizer shaft.

Installation Procedure





1. Install the insulators to the stabilizer shaft.
2. Install the stabilizer shaft.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Use new stabilizer shaft insulator bolts.

3. Install the stabilizer shaft insulator bolts.
- Use the J 36660-A
4. Install the engine front crossmember frame.
5. Lower the vehicle.