Radio Replacement (With RPO Code UY4)

REMOVAL PROCEDURE




1. Remove the rear shelf trim panel.
2. Remove the rear shelf carrier panel.
3. Remove the fasteners (4) retaining the radio (5) to the radio / navigation processor bracket.
4. Disconnect the electrical connectors (1, 3) and the antenna (2) from the radio (5).
5. Remove the radio (5) from the radio / navigation processor bracket.

INSTALLATION PROCEDURE




1. Install the radio (5) to the radio / navigation processor bracket.
2. Reconnect the antenna (2) and the electrical connectors (1, 3) to the radio (5).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the fasteners (4) that retain the radio (5) to the radio / navigation processor bracket.

Tighten
Tighten the radio fasteners to 5 N.m (44 lb in).

4. Install the rear shelf carrier panel.
5. Install the rear shelf trim panel.

"For the description of RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at the Vehicle/Application and ID." RPO Codes