Center Seat Replacement (UV8)

Center Seat Replacement (UV8)

Removal Procedure
Caution: Refer toSIR Caution in Cautions and Notices.

1. Disable air bag system. Refer to Disabling the SIR System in SIR
2. Remove the docking station from the center seat storage compartment. Refer to Cellular Telephone Docking Station Replacement (Base and DHS) Cellular Telephone Docking Station Replacement (DTS) in Cellular Communications.
3. Remove the fasteners retaining the docking station adapter to the center seat.
4. Lift up the docking station adapter and disconnect the coaxial antenna cable from the cellular phone coil cord.
5. Remove the two fasteners from the interface card.
6. Remove the interface card from the docking station adapter and disconnect the electrical connector from the interface card.
7. Push the cellular phone coaxial cable and the interface card electrical connector through the opening in the bottom of the center seat storage compartment.
8. Adjust both the left and the right front seats to the rear.




9. Remove the two front center seat to floor fasteners (1).
10. Adjust both the left and the right front seats forward.
11. Remove the two rear center seat to floor fasteners (2).
12. Lift the center seat (3) in order to access the center seat electrical connector (4).
13. Remove the front center seat (3) from the vehicle.



Installation Procedure





1. Install the center seat (3) to the vehicle.
2. Pull the cellular phone wiring through the opening in the bottom of the center seat storage compartment.
3. Connect the interface card electrical connector.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the interface card to the docking station adapter.

Tighten the fasteners to 1.6 N.m (14 lb in).

5. Connect the coaxial cable to the coil cord.
6. Install the docking station adapter to the center seat.

Tighten the fasteners to 1.6 N.m (14 lb in).

7. Install the docking station to the docking station adapter. Refer to Cellular Telephone Docking Station Replacement (Base and DHS) Cellular Telephone Docking Station Replacement (DTS) in Cellular Communications.
8. Connect the center seat electrical connector (4).
9. Adjust both the left and the right front seats forward.
10. Install the two rear fasteners (2) to the center seat (3).

Tighten the fasteners (2) to 9 N.m (80 lb in).

11. Adjust both the left and the right front seats to the rear.
12. Install the two front fasteners (1) to the center seat (3).

Tighten the fasteners (1) to 9 N.m (80 lb in).

13. Enable the SIR system. Refer to Enabling the SIR System in SIR.