Head Up Display Module Replacement

REMOVAL PROCEDURE

CAUTION: Refer to SIR Handling Caution in Service Precautions.




1. Remove the instrument panel upper trim pad.
2. Remove the fasteners (3) from the head up display module (HUD) (1).
3. Disconnect the electrical connector (2) from the HUD module.
4. Remove the HUD module (1) from the instrument panel.

INSTALLATION PROCEDURE




1. Connect the electrical connector (2) to the head up display module (HUD) (1).
2. Install the HUD module (1) to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the fasteners (3) into the HUD module (1).

Tighten
Tighten the fasteners to 2 N.m (18 lb in).

4. Install the instrument panel upper trim pad.