Night Vision Camera Replacement (Design 2)

REMOVAL PROCEDURE

IMPORTANT:
^ The first design night vision camera is not serviceable and must be sent to an authorized service center for repair.
The second design night vision camera has a serviceable window/lens. The second design camera can be recognized by the electrical connection below the window/lens.
^ If the night vision camera is removed or adjusted for any reason, it must be aimed. Refer to Night Vision Camera Aiming.




1. Open and support the hood.
2. Disconnect the night vision camera (1) electrical connectors (2).




3. Turn the three camera retainers (1) 90 degrees in order to remove the camera from the mounting bracket.
4. Remove the night vision camera.

INSTALLATION PROCEDURE

IMPORTANT: Make sure the retainers are fully turned and in the locked position.




1. Install the night vision camera to the mounting bracket and turn the retainers (1) 90 degrees.




2. Connect the electrical connectors (2).
3. Perform aiming procedure for night vision camera (1). Refer to Night Vision Camera Aiming.