Console Replacement - Without UV8

REMOVAL PROCEDURE

CAUTION: Refer to SIR Handling Caution in Service Precautions.




1. Disable the SIR. Refer to Disabling the SIR System in Restraint Systems.
2. Set the parking brake.
3. Remove the left console trim panel.
4. Remove the right console trim panel.
5. Remove the console center trim plate.
6. Remove the IP center compartment.
7. Remove the left knee bolster.
8. Remove the right knee bolster.
9. Disconnect the transaxle range selector cable terminal from the shift lever pin.
10. Pull the lock release and remove the transaxle shift cable from the console.




11. Remove the 4 console fasteners (1,2) to the IP.
12. Adjust the front seats rearward.
13. Remove the 2 front console to floor fasteners (3).
14. Adjust the front seats forward.
15. Remove the 2 rear console to floor fasteners (4).
16. Move the console rearward, in order to access the electrical connectors.
17. Disconnect the center console electrical connectors.
18. Remove the center console.

INSTALLATION PROCEDURE




1. Install the center console to the vehicle.
2. Connect the center console electrical connectors.
3. Align the locating pins on the center console to the IP.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the 2 upper console to IP fasteners (1).

Tighten
Tighten the fasteners (1) to 9 N.m (80 lb in).

5. Install the 2 lower console to IP fasteners (2).

Tighten
Tighten the fasteners (2) to 9 N.m (80 lb in).

6. Adjust the front seats to the forward position.
7. Install the 2 rear console to floor fasteners (4).

Tighten
Tighten the fasteners (4) to 9 N.m (80 lb in).

8. Adjust the front seats to the rear position.
9. Install the 2 front console to floor fasteners (3).

Tighten
Tighten the fasteners (3) to 9 N.m (80 lb in).

10. Install the IP center compartment.




11. Slide the transaxle range selector cable fully into the console until it snaps into place.
12. Connect the transaxle range selector cable terminal to the shift lever pin.
13. Install the console center trim plate.
14. Install the right knee bolster.
15. Install the left knee bolster.
16. Install both the left and the right console trim panels.
17. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.

"For the description of RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at the Vehicle/Application and ID." RPO Codes