Power Seat Drive Cable Replacement

Power Seat Drive Cable Replacement

Removal Procedure

Caution: Refer toSIR Caution in Cautions and Notices.
1. Disable the SIR. Refer to Disabling the SIR System in SIR.
2. Remove the seat bottom and frame assembly. Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.




4. Squeeze the collar of the cable in order to release the cable.




5. Pull the cable out of the fitting until the cable end clears the fitting.
6. Remove the cable or cable/sensor assembly.



Installation Procedure





1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the seat bottom and frame assembly. Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
4. Enable the SIR. Refer to Enabling the SIR System in SIR.