Rear Electrical Center Replacement

REMOVAL PROCEDURE




1. Disconnect the negative battery cable from the battery.
2. Remove the rear fuse block cover.
3. Remove the positive battery cable fastener (1) from the battery cable.
4. Remove the positive battery cable from the rear fuse block.
5. Unclip the four retaining clips, lift the electrical fuse block up and turn over.
6. Remove the three connector fasteners and remove all the connectors from the fuse block.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install all the connectors to the rear fuse block and hand start the fasteners.

Tighten
Tighten the fasteners to 6 N.m (53 lb in).

2. Install the rear fuse block into the base assembly ensuring all the clips engage.
3. Install the positive battery cable and fastener (1) to the rear fuse block.

Tighten
Tighten the fastener to 15 N.m (11 lb ft).

4. Connect the negative battery cable from the battery.