Ground Strap: Service and Repair
GROUND STRAP REPLACEMENTREMOVAL PROCEDURE
IMPORTANT:
^ Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
^ Always route the replacement cable the same way as the original cable.
1. Remove the upper filler panel.
2. Remove the bolt (1) securing the engine ground cable (2) to the right side body frame rail.
3. Remove the bolt securing the engine ground cable to the generator.
4. Remove the engine ground cable from the vehicle.
INSTALLATION PROCEDURE
1. Position the engine ground cable to the engine.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt securing the engine ground cable to the generator.
Tighten
Tighten the generator mounting bolt to 50 N.m (37 lb ft).
3. Install the bolt (1) securing the engine ground cable (2) to the right side body frame rail.
Tighten
Tighten the engine ground cable bolt to 50 N.m (37 lb ft).
4. Install the upper filler panel.