Navigation Module: Service and Repair
NAVIGATION DISPLAY MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the Heater and A/C (HVAC) control.
2. Push and hold the release tabs (2) on the left and right sides of the navigation display (1) in order to release the navigation display (1) from the IP.
3. Partially remove the navigation display from the IP in order to disconnect the electrical connector (1) from the navigation display.
4. Remove the navigation display from the IP.
INSTALLATION PROCEDURE
1. Partially install the navigation display in order to connect the electrical connector (1).
2. Align the navigation display alignment pins to the IP opening, push the navigation display (1) toward the front of the vehicle until an audible click is heard.
3. Pull on the navigation display (1) in order to verify the navigation display is secured to the IP.
4. Install the HVAC control.