Inflatable Restraint Instrument Panel Module Replacement
REMOVAL PROCEDURECAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
1. Disable the SIR system.
2. Remove passenger (right) insulator panel.
3. Remove the Connector Position Assurance (CPA) (4) from the Inflatable Restraint Instrument Panel (IP) module connector (2).
4. Remove the inflatable restraint IP module yellow connector (2) from the vehicle wiring harness yellow connector (1).
5. Remove the inflatable restraint IP module yellow connector (2) from the IP bracket (3).
6. Remove the IP upper trim pad.
7. Note the inflatable restraint IP module wire harness routing position, to help in re-assembly.
8. Push the inflatable restraint IP module yellow connector (2) back away from the IP (3).
9. Remove the inflatable restraint IP module mounting fasteners (2).
10. Remove the inflatable restraint IP module (3) from the IP (1).
11. When removing the inflatable restraint IP module (3) care must be taken not to damage inflatable restraint IP module pigtail and connector (4).
INSTALLATION PROCEDURE
1. When installing the inflatable restraint IP module (3) care must be taken not to damage inflatable restraint IP module pigtail and connector (4).
2. Route the inflatable restraint IP module pigtail (4) down through the IP (1).
3. Install the inflatable restraint IP module (3) to the instrument panel (1).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the inflatable restraint IP module mounting fasteners (2).
Tighten
Tighten fasteners to 22 N.m (16 lb ft).
5. Route the inflatable restraint IP module wiring harness (2) in place to secure inflatable restraint IP module yellow connector clip to IP (3).
6. Install the IP upper trim pad.
7. Clip the inflatable restraint IP module yellow connector (2) to IP bracket (3).
8. Install the inflatable restraint IP module yellow connector (2) to the vehicle harness yellow connector (1).
9. Install the Connector Position Assurance (CPA) (4) to the inflatable restraint instrument panel (IP) module connector (2).
10. Install passenger (right) insulator panel.
11. Enable the SIR system.