Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Upper Bearing Spring Replacement - On Vehicle

- Tools Required
- J 23653-SIR Lock Plate Compressor.

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in Restraint Systems.
3. Using J 23653-SIR remove the bearing retainer.





4. Remove the shaft lock shield assembly (1).
5. Remove the turn signal cancel cam assembly (2).
6. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install the bearing retainer.





5. Using J 23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove the J 23653-SIR from the steering shaft.
8. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in Restraint Systems.
9. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.