Electric Park Lock Module - Assemble

1. Snap the electric park lock (1) onto the lock module assembly.
2. Install the tapping screw (3) into the electric park lock (1) mounting hole and the ignition and key alarm switch assembly.
3. Install the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle.
4. Install the black connector into the electric park lock (2).





5. If necessary, install the steering column closeout trim covers to the upper trim covers.





6. Install the upper trim covers (1).

Notice: Refer to Fastener Notice in Service Precautions.

7. Install 1 pan head tapping screw (2) to the upper trim covers (1).
- Tighten the pan head tapping screw to 1.5 Nm (13 inch lbs.).





8. If necessary pop the power tilt and telescope toggle switch assembly (3) into the lower trim covers (2).
9. Install the lower trim covers (2) onto the steering column.
10. Attach the steering column closeout trim covers (1) to the lower trim covers (2).
11. Install the 2 pan head tapping screws (4) to the lower trim covers (2).
- Tighten the pan head tapping screws to 3 Nm (27 inch lbs.).





12. Connect the connector of the power tilt and telescope toggle switch assembly into the telescope module at the base of the column.
13. Install the necessary wire harness straps.