Ignition & Key Alarm Switch - Disassemble

1. Remove the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle.
2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle.
3. Disconnect the coded key controller connector.





4. Slide the coded key controller (2) from the lock module assembly (1).





5. Disconnect the connector from the bottom of the ignition and key alarm switch assembly (2).
6. Remove the lead inside the clip on the side of the ignition and key alarm switch assembly (2).
7. Remove the key alarm connector (1) from the lock module assembly (4).
8. Remove the 2 tapping screws (3) from the ignition and key alarm switch assembly (2).