Turn Signal & Multifunction Switch - Assemble

1. Install the turn signal and multifunction switch assembly (3) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lower pan head tapping screw (2) first.
- Tighten the lower pan head tapping screw to 2.5 Nm (22 inch lbs.).
3. Install the top pan head tapping screw (1) last.
- Tighten the top pan head tapping screw to 2.5 Nm (22 inch lbs.).
4. Connect the connector(s) to the turn signal and multifunction switch assembly (3).
5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.