Power Mirror Replacement

Power Mirror Replacement

Removal Procedure

1. Remove the door trim panel to gain access to the power mirror wire harness connector. Refer to Front Side Door Trim Panel Replacement (Standard) (Front Side Door Trim Panel Replacement (Standard)) .
2. Remove the garnish molding. Refer to Front Side Door Opening Frame Garnish Molding Replacement (Front Side Door Opening Frame Garnish Molding Replacement) .




3. Disconnect the power mirror wire harness electrical connector (5) from the door module.
4. Disconnect the wire harness from the retainer clip (4).
5. Remove the mirror fasteners (3).
6. Remove the mirror (1) from the door.
7. Unseat the grommet (2).
8. Pull the wiring harness through the hole in the mirror patch.



Installation Procedure





1. Route the mirror wiring harness through the hole in the mirror patch.
2. Seat the grommet (2).
3. Install the mirror (1) into the door frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the mirror fasteners (3).

Tighten the mirror fasteners, in this order: forward, top, rear, to 9 N.m (80 lb in).

5. Install the mirror wire harness into the retainer clip (4).
6. Connect the power mirror electrical connector (5) to the door module.
7. Install the garnish molding. Refer to Front Side Door Opening Frame Garnish Molding Replacement (Front Side Door Opening Frame Garnish Molding Replacement) .
8. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement (Standard) (Front Side Door Trim Panel Replacement (Standard)) .