Backup Lamp: Service and Repair

BACKUP LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Pull down the rear compartment lid trim. Refer to Compartment Lid Trim Replacement - Rear in Trunk/Liftgate.
2. Disconnect the electrical connector.




3. Remove the fasteners that secure the backup lamp assembly.
4. Remove the backup lamp assembly.




5. Remove the bulb assembly.
6. Remove the bulb.

INSTALLATION PROCEDURE




1. Install the bulb into the bulb socket.
2. Install the bulb assembly into the backup lamp assembly.
3. Pull the wire harness through the body and seat the grommet.
4. Install the backup lamp assembly to the rear compartment lid.

NOTE: Refer to Fastener Notice in Service Precautions.




5. Install the fasteners in order to secure the backup lamp assembly.

Tighten
Tighten the fasteners to 4.5 N.m (40 lb in).




6. Connect the electrical connector.
7. Install the rear compartment lid trim.