Operation CHARM: Car repair manuals for everyone.

Oil Level Sensor: Service and Repair

ENGINE OIL LEVEL SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement in Engine Mechanical-4.6 L.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Disconnect the electrical connector (2) from the oil level sensor (1).
4. Remove the oil level sensor (1) from the oil pan.

INSTALLATION PROCEDURE

NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.




1. Install the oil level sensor (1) to the oil pan.

Tighten
Tighten the oil level sensor (1) to 20 N.m (15 lb ft).

2. Connect the electrical connector (2) to the oil level sensor (1).
3. Lower the vehicle.
4. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement in Engine.
5. Start the engine and check for leaks.