SIR Steering Wheel Module Coil - Assemble

Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.





1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.

Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.





2. If installing the existing inflatable restraint steering wheel module coil it must be centered first. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift).
3. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
4. Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
5. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
6. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).
7. Connect the connector of the inflatable restraint steering wheel module coil to the wire harness assembly.
8. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.