Multifunction, Turn Signal Lever

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement- On Vehicle.
3. Remove the multifunction switch retaining screws.
4. Disconnect the multifunction switch electrical connections.
5. Remove the multifunction switch.

Installation Procedure





1. Connect the multifunction switch electrical connectors.
2. Install the multifunction switch to the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the multifunction switch retaining screws.
- Tighten the multifunction switch retaining screws to 7 Nm (62 inch lbs.).
4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle.
5. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.