Steering Column Control Module - Programming

Tilt/Telescoping Soft Stop Programming Procedure
1. Turn ignition to ON, leaving the engine off.
2. To set the tilt up soft stop, press the Tilt/Telescoping COLUMN UP switch at least eight times or until the column moves, then release the switch.
3. Press the Tilt/Telescoping COLUMN UP switch and hold the switch until the column travels all the way up, and continue to hold the switch about a second after motion stops at the mechanical end of travel. The soft stop for the column up position is now set. The Tilt/Telescoping module automatically goes back to the normal mode of operation.
4. Repeat steps 2 and 3, using the COLUMN DOWN switch, to set the column down position soft stop.
5. Repeat steps 2 and 3, using the COLUMN IN switch, to set the column in position soft stop.
6. Repeat steps 2 and 3, using the COLUMN OUT switch, to set the column out position soft stop.