Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOPLAMP REPLACEMENTREMOVAL PROCEDURE
1. Slide the carpet-trimmed cover toward in order to disengage the high-mounted stoplamp cover from the rear shelf panel.
2. Remove the fastener (4).
3. Pull the stoplamp (1) toward the front of the vehicle and up in order to disengage the retainers.
4. Disconnect the electrical connectors (5) from the bulbs (3).
5. Remove the stoplamp (1).
INSTALLATION PROCEDURE
1. Connect the electrical connectors (5) to the bulbs (3).
2. Install the stoplamp (1) to the rear shelf.
3. Engage the stoplamp (1) to the retainer slots in the rear shelf panel (2).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the fastener (4).
Tighten
Tighten the fastener to 2 N.m (18 lb in).
5. Slide the high-mounted stoplamp cover rearward in order to engage the retainer clips to the rear shelf panel.