Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the electrical connector at the vehicle speed sensor.
3. Remove the retaining bolt (131) and the sensor (130). Twisting the sensor while pulling outward will aid in removal.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.
^ Tighten the bolt to 10 Nm (89 inch lbs.).
2. Install the electrical connector at the sensor.
3. Lower the vehicle.