C0695

DTC C0695





Circuit Description
The Continuously Variable Road Sensing Suspension (CVRSS) module provides power (a regulated 8 volts) to each of the position sensors. The control module also monitors this voltage supply for a fault condition which prevents proper regulation.

Conditions for Running the DTC
The ignition is ON.

Conditions for Setting the DTC
- The position sensor supply voltage is outside the valid range of 6 to 9 volts.
- The fault is detected for 1 second or more during three consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with a scan tool.

Action Taken When the DTC Sets
- The CVRSS module will enter the Speed Dependent damping mode.
- Both Left and Right Normal Force outputs will be set to the default output states.
- The SERVICE RIDE CONTROL message will be displayed.

Conditions for Clearing the MIL/DTC
- The scan tool can be used to clear the DTC.
- The On-Board diagnostic CLEAR RSS CODES feature can be used to clear the DTC.
- The DTC is saved as history when the CVRSS module no longer sees a position sensor supply voltage outside the valid range of 6 to 9 volts. The DTC will clear if the fault does not return after 50 consecutive ignition cycles.

Test Description

Important
- Do not backprobe the sensors, actuators, or any sealed connectors.
- When all the diagnostics and repairs are complete, clear the DTCs and verify the operation.

The number(s) below refer to the step number(s) on the diagnostic table.
2. Determines if the fault is due to a short to ground condition.
3. Determines if the fault is due to a short to voltage condition.
4. Tests for a short to ground in the position sensor supply circuits.
5. Tests for a short between the position sensor supply and ground circuits.
6. Tests for a short to voltage in the position sensor supply circuits.