Mirror Replacement - Power Mirror

REMOVAL PROCEDURE




1. Remove the trim panel.
2. Remove the water deflector.
3. Disconnect the electrical connector (4).
4. Remove the mirror assembly fasteners (3).
5. Carefully guide the electrical harness through the door from between the inner panel and the impact bar.
6. Remove the mirror assembly (2) from the door.

INSTALLATION PROCEDURE




1. Carefully route the electrical harness through the door in between the inner panel and side impact bar.
2. Install the mirror assembly (2) to the door.
3. The mirror must be parallel to the edge of the mucket within 2 mm.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the fasteners (3) that secure the mirror to the door.

Tighten
- Tighten the 2 bottom nuts first to 6 N.m (53 lb in).
- Tighten the top nut last to 6 N.m (53 lb in).

5. Connect the electrical connector (4).
6. Install the water deflector.
7. Install the trim panel.