Parking Lamp: Service and Repair
PARK/[1][2]TURN SIGNAL LAMP REPLACEMENTREMOVAL PROCEDURE
1. Remove the upper filler panel.
2. Remove the fastener.
3. Pull outward the front edge of the [1][2]turn signal lamp housing.
4. Carefully release the tabs at the rear of the cornering lamp housing.
5. Twist the electrical sockets counter-clockwise 45 degrees in order to release the lamp sockets from the housing.
6. Remove the [1][2]turn signal lamp housing.
INSTALLATION PROCEDURE
1. Position the lamp sockets to the [1][2]turn signal lamp housing.
2. Twist the lamp socket 45 degrees clockwise in order to secure the sockets to the housing.
3. Position the [1][2]turn signal lamp housing tabs into the slots in the headlamp panel housing assembly.
4. Move the front edge of the [1][2]turn signal lamp housing toward the headlamp.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the fastener in order to secure the [1][2]turn signal lamp housing.
Tighten
Tighten the fastener to 6 N.m (53 lb in).
6. Install the filler panel.