Tail Lamp: Service and Repair

TAILLAMP REPLACEMENT

REMOVAL PROCEDURE




1. Open the rear compartment lid.
2. Remove the rear compartment trim.
3. Remove the wing nuts securing the tail lamp to the rear end body panel.




4. Disconnect the bulb sockets (1,2,3).
5. Disengage the retainer securing the electrical harness to the tail lamp.
6. Remove the tail lamp assembly.

INSTALLATION PROCEDURE




1. Partially install the tail lamp assembly.
2. Connect the bulb sockets.
3. Engage the clip for the electrical harness.
4. Ensure the foam gaskets are in place over the studs.




5. Position the lamp (2) to the rear end body panel.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the wing nuts (1) in order to secure the tail lamp (2).

Tighten
Tighten the wing nuts to 4.5 N.m (40 lb in).

7. Install the rear compartment trim.