Window Upstop Adjustment

IMPORTANT: The window upstop adjusters (3) are color coded in the following manner:
- The front upstop adjuster is a neutral color.
- The rear adjuster is black.

The adjuster has a 6 mm (0.23 in) head. One full turn equals 1 mm (0.04 in) of movement of the glass.

While facing the door inner panel, the following conditions may be observed:
- A clockwise rotation moves the window up.
- A counterclockwise rotation moves the window down.

Lower the window slightly in order to relieve pressure before moving the adjusters.




1. Remove the roof rail weather-strip.
2. Insert a 2.6 cm (1 in) wide roll of masking tape (2) in the weather-strip retainer assembly (3).
3. Place the window in the full up position.
4. Close the door.
5. Measure the gap between the edge of the weather-strip retainer assembly (3) and the top edge of the window.
Ensure that the gap is 3 mm (0.125 in).
6. If the gap is not within specifications, perform the following steps:
6.1. Determine the necessary amount of movement for the assembly.
6.2. Adjust the upstops, as needed.
7. Reinstall the roof rail weather-strip.
8. Install the water deflector.
9. Install the speaker assembly.
10. Install the door trim panel.