Wiper Motor Park Switch Replacement

REMOVAL PROCEDURE




1. Remove the wiper motor.
2. Remove the three screws and the wiper motor cover.

IMPORTANT: If the wiper motor is in the park position, operate the wiper motor as required to remove the pawl from the relay slot.




3. Remove the screw and the park switch assembly.

INSTALLATION PROCEDURE




1. Install the new park switch assembly and screw.




2. Operate the wiper motor back into the park position (the pawl in the relay slot).

IMPORTANT: Ensure that the drive pin is in the open area of the cam.

3. Install the wiper motor cover.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the three screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).

5. Install the wiper motor.