C1246

DTC C1246





Test 1-5





Test 6-14

Circuit Description
The brake pad wear sensor signal is normally grounded at the EBCM through the brake pad wear sensors in a series circuit.


Conditions for Running the DTC
The stoplamp switch is open.


Conditions for Setting the DTC
The brake pad wear sensor signal voltage is greater than 2.93 volts for 1 second.


Actions Taken When the DTC Sets
The DIC displays the Check Brake Pads message.


Conditions for Clearing the DTC
^ The condition for the DTC is no longer present (the DTC is not current) and you used the scan tool Clear DTC function.
^ The condition for the DTC is no longer present (the DTC is not current) and you used the On-Board Diagnostics Clear DTC function.
^ The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.