Electronic Suspension Control Module Replacement

Removal Procedure

1. Remove the rear compartment trim panel. Refer to Compartment Trim Panel Replacement- Rear in Body and Frame.
2. Access the rear electronics compartment.
3. Disconnect the electrical connectors from the CVRSS module.





4. Remove the CVRSS module from the right electronics bay.

Installation Procedure





1. Install the CVRSS module in the right electronics bay.
2. Connect the electrical connectors to the CVRSS module.
3. Close the rear electronics compartment.
4. Install the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - rear in Body and Frame.
5. Perform the CVRSS module Calibration. Refer to Electronic Suspension Control Module Calibration. Programming and Relearning