Operation CHARM: Car repair manuals for everyone.

Engine Oil Level Sensor Replacement

REMOVAL PROCEDURE




1. Drain the engine oil.
2. Raise and support the vehicle.
3. Disconnect the electrical connector (2) from the oil level sensor (1).
4. Remove the oil level sensor (1) from the oil pan.

INSTALLATION PROCEDURE

NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.




1. Install the oil level sensor (1) to the oil pan.

Tighten
Tighten the oil level sensor (1) to 20 N.m (15 lb ft).

2. Connect the electrical connector (2) to the oil level sensor (1).
3. Lower the vehicle.
4. Fill the engine oil.
5. Start the engine and check for leaks.