Left

Install new M11 cylinder head bolts in the cylinder head.

Install the M6 cylinder head bolts at the front of the cylinder head.

Notice: Refer to Fastener Notice in Service Precautions.





Tighten the left cylinder head bolts in the sequence shown.
1. First Pass
Tighten the left cylinder head M11 cylinder head bolts to 40 Nm (30 ft. lbs.) in the sequence shown.

2. Second Pass
Using the J 36660-A, tighten the left cylinder head M11 cylinder head bolts an additional 70 degrees in the sequence shown.

3. Third Pass
Repeat the sequence turning each bolt another 60 degrees.

4. Final Pass
Repeat the sequence again turning each bolt a final 60 degrees (total 190 degrees).

Tighten the M6 bolts at the front of the cylinder head.
Tighten the M6 cylinder head bolts to 12 Nm (106 inch lbs.).