Tail/Turn Signal Lamp Replacement

REMOVAL PROCEDURE




1. Open the rear compartment lid.
2. Remove the rear compartment sill plate.
3. Pull back on the rear compartment trim panel.
4. Disconnect the taillamp connector (3).
5. Press the grommet (2) out of the rear compartment.
6. Remove the nuts (5) retaining the taillamp (1) to the body.
7. Remove the taillamp (1) from the body.

INSTALLATION PROCEDURE




1. Route the taillamp connector (3) and the grommet (2) through the body.
2. Verify that the grommet (2) is fully seated in the body.
3. Install the taillamp (1) to the body.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the nuts (5) that retain the taillamp (1) to the body.

Tighten
Tighten the nuts to 4.5 N.m (40 lb in).

5. Connect the taillamp connector (3).
6. Install the rear compartment sill plate.
7. Close the rear compartment lid.