Suction Hose Replacement
TOOLS REQUIREDJ 39400 Electronic Halogen Leak Detector
REMOVAL PROCEDURE
1. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging.
2. Remove the suction hose retaining nut from the accumulator.
3. Remove the suction hose from the accumulator.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Remove the front air deflector.
6. Disconnect the suction hose from the compressor.
7. Remove the suction hose.
INSTALLATION PROCEDURE
1. Install the suction hose.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Connect the suction hose to the compressor.
Tighten
Tighten the suction hose to 20 N.m (15 lb ft).
3. Lower the vehicle.
4. Install the suction hose to the accumulator.
5. Install the suction hose retaining nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the suction hose to 20 N.m (15 lb ft).
6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
7. Leak test the fittings of the repaired or reinstalled component using J 39400.
8. Install the front air deflector.