With RPO FE7
Stabilizer Shaft Replacement (FE7)Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft links.
3. Remove the stabilizer shaft bracket bolts.
4. Bend open the end of the stabilizer shaft bracket and slide over the stabilizer shaft insulators.
5. Remove the stabilizer shaft insulators.
6. Remove the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft.
2. Install the stabilizer shaft insulators to the stabilizer shaft with the slit facing forward.
3. Bend the stabilizer shaft bracket downward to close around the stabilizer shaft insulator.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Ensure the stabilizer shaft is centered before installing the bracket bolts.
4. Install the stabilizer shaft bracket bolts
^ Tighten the stabilizer shaft bracket bolts to 51 Nm (38 ft. lbs.).
5. Install the stabilizer shaft links.
6. Lower the vehicle.