Ignition & Key Alarm Switch - Assemble

Ignition and Key Alarm Switch Assembly -Assemble - Off Vehicle

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).
^ Tighten the screws to 1.5 Nm (13 inch lbs.).
2. Install the ignition and key alarm connector (1) onto the lock module assembly (4).
3. Install the green connector into the bottom of the ignition and key alarm switch assembly (2).
4. Put the lead in the clip located on the side of the ignition and key alarm switch assembly (2).





5. Install the coded key controller (2) onto the lock module assembly (1).





6. Connect the coded key controller.
7. Install the upper and lower trim cover.
8. Install the steering column lock cylinder set.
9. Install the steering column into the vehicle.
10. Install the steering wheel onto the steering column.
11. Enable the inflatable restraint steering wheel module.