Radio Replacement (With RPO Code U3Q, U3R, U3S)

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) center trim plate.
2. Remove the heating ventilation and air conditioning (HVAC) control.
3. Push and hold the release tabs on the left and right sides of the navigation radio in order to release the navigation radio from the IP.




4. Partially remove the navigation radio from the IP in order to disconnect the antennas and the electrical connections.
5. Remove the navigation radio from the IP.

IMPORTANT: New and remanufactured navigation radio (3) do not include the mounting brackets (2), studs (4) or nuts (1). The hardware will need to be transferred to the replacement navigation radio (3).




6. If the navigation radio is to be replaced, remove the hardware (1, 2, 4) from the original navigation radio (3).

INSTALLATION PROCEDURE




1. Install the mounting hardware (1, 2, 4) to the navigation radio (3).




2. Partially install the navigation radio in order to connect antennas and electrical connector.




3. Align the navigation radio alignment pins to the IP opening and push the navigation radio towards the front of the vehicle until an audible click is heard.
4. Tug on the navigation radio in order to verify the navigation. radio is secure.
5. Install the HVAC control.
6. Install the IP center trim plate.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes