Seat Replacement - Center (With RPO Code UV8)

Seat Replacement - Center (UV8)

Removal Procedure
Caution: Refer toSIR Caution in Cautions and Notices.





1. Disable air bag system. Refer toDisabling the SIR System in SIR.
2. Adjust both the left and the right front seats to the rear.
3. Remove the two front center seat bolts (1).
4. Adjust both the left and the right front seats forward.
5. Remove the two rear center seat bolts (2).
6. Lift the center seat (3) in order to access the center seat electrical connector (4).




7. Disconnect the cellular phone electrical connector (1).
8. Disconnect the cellular phone coaxial cable (2).
9. Remove the front center seat from the vehicle.
10. If the center seat assembly is being replaced, remove the docking station and adapter from the center seat. Refer toCellular Telephone Docking Station Replacement (DTS) Cellular Telephone Docking Station Replacement (DeVille and DHS) in Cellular Communication.



Installation Procedure





1. Install the docking station and docking station adapter to the center seat. Refer toCellular Telephone Docking Station Replacement (DTS) Cellular Telephone Docking Station Replacement (DeVille and DHS) in Cellular Communication.
2. Install the center seat to the vehicle.
3. Connect the cellular phone electrical connector (1).
4. Connect the cellular phone coaxial cable (2).




5. Connect the center seat (3) electrical connector (4).
6. Adjust both the left and the right front seats forward.

Notice: Refer toFastener Notice in Cautions and Notices.

7. Install the two rear bolts (2).

Tighten the bolts (2) to 9 N.m (80 lb in).

8. Adjust both the left and the right front seats to the rear.
9. Install the two front bolts (1).

Tighten the bolts (1) to 9 N.m (80 lb in).

10. Enable the SIR system. Refer toEnabling the SIR System in SIR.