Tilt Motor - Assemble

Tilt Motor Assembly - Assemble -Off Vehicle





1. Install the black end of the tilt cable assembly to the steering column.
2. Install the white end of the tilt cable assembly to the tilt drive motor assembly.





3. Snap on the potentiometer housing. (1).
4. Install the tilt drive motor assembly (2) to the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install 2 TORX head screws (3).
^ Tighten the screws to 2 Nm (18 inch lbs.).

Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.

6. Connect the connectors of the tilt drive motor assembly (2).
7. Install the steering column into the vehicle.
8. Install the steering wheel onto the steering column.
9. Enable the inflatable restraint steering wheel module.